Sea Ray 290 Sundancer Owner's Manual Page 143
- Page / 150
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
9.1
SECTION 9 • CARE & REFINISHING
290 Sundancer
®
2. FIBERGLASS AND GELCOAT
The fi berglass hull, deck and some interior parts
consist of a molded shell and exterior gelcoat.
The gelcoat is the outer surface, often colored,
that presents the shiny smooth appearance
associated with fi berglass products. This gelcoat
surface is painted or taped in some areas for styling
purposes.
Wash the gelcoat and fi berglass regularly with clean,
fresh water. Wax gelcoat surfaces to maintain the
luster. In northern climates, a waxing at the start and
end of the boating season may suffi ce. In southern
climates, an application of wax every three months
will be required for adequate protection.
REFER TO THE “3M
®
ONE STEP MAINTENANCE AND
RECONDITIONING PRODUCTS” PAMPHLET IN YOUR
OWNER’S MANUAL PACKET FOR INSTRUCTIONS
AND WARRANTY INFORMATION.
Your new boat has been designed to provide you
with years of enjoyment and satisfaction. In order to
maintain the factory new appearance of your boat,
we recommend the use of 3M™ Marine's one
step Maintenance and Reconditioning Products
designed specifi cally for pleasure boats. Following
proper fi berglass maintenance guidelines will help
maintain your boat's performance, value, and
enjoyment.
Gelcoat surfaces are slippery when wet.
Always wear nonslip footwear securely fastened to
your feet and hold on to rails or the boat structure.
! WARNING
Waxed surfaces are slippery.
Do not wax areas that are usually walked on.
! WARNING
1. PAINT CLEANING AGENTS AND
OTHER SUBSTANCES
Do not use products containing chlorine, phosphates,
perfumes and nondegradable ingredients. Consult
your marine dealer regarding environmental
regulations before painting the hull. Fumes can
last for hours, and chemical ingredients can harm
people, property and the environment. Common
household cleaning agents may cause hazardous
reactions. Read and understand directions on all
paint, cleaning and polishing materials before
using.
EXPLOSION/FIRE HAZARD
Care and refi nishing materials may contain
ingredients that are fl ammable or explosive. Do not
use such materials in the bilge
Shut off electrical power and ventilate when using
such materials anywhere on the boat or in the cabin.
Do not create sparks or use lighted materials.
! WARNING
A. KEEP BILGE AREA DRY
Water may accumulate in the engine room where
it is not able to drain to the bilge pump. Check all
areas of the engine room for accumulated water and
dry thoroughly. Water left standing may penetrate
through the gelcoat surfaces and wick into the
fi berglass affecting the life of the product.
- 290 Sundancer 1
- HIS MANUAL 5
- OUR RESPONSIBILITIES 5
- OURCES OF INFORMATION 5
- INTRODUCTION 6
- ERVICE, PARTS AND REPAIR FOR 7
- OUR BOAT 7
- ABOUT YOUR LIMITED WARRANTY 8
- NTRODUCTION 9
- ECTION 3 • USING YOUR BOAT 9
- ECTION 5 • FUEL SYSTEM 10
- ECTION 6 • ELECTRICAL SYSTEM 10
- AINTENANCE 11
- SECTION 1 • SAFETY 13
- ECTION 1 • SAFETY 22
- E. COLLISIONS AND LEAKING 24
- F. GROUNDING 24
- 22. WARNING LABEL LOCATIONS 29
- WARNING LABEL LOCATIONS 30
- (FIG. 1.18.1) 30
- ARNING LABEL LOCATIONS 31
- IG. 1.19.1) 31
- DO NOT CLIMB UPON OR STORE 31
- EQUIPMENT ON HARDTOP 31
- 1. DOCKING/ LIFTING/ STORAGE 33
- 2. PASSENGER LOCATIONS 34
- ! DANGER 35
- 3. PROPULSION SYSTEM 36
- (FIG. 2.5.1) 37
- 290 SUNDANCER 37
- 5. DECK LAYOUT 38
- 6. CABIN LAYOUT 39
- (FIG. 2.8.1) 40
- (FIG. 2.8.2) 40
- WITCH PAD 41
- IG. 2.9.1) 41
- IG. 2.9.2) 41
- HELM LAYOUT (FIG. 2.10.1) 42
- ! CAUTION 44
- B. POWER TRIM UNIT AND GAUGE 44
- TTITUDE LIST PUSH 45
- 10. IMPORTANT GAUGES 46
- (FIG. 2.15.1) 47
- SECTION 3 • USING YOUR BOAT 49
- 1. BILGE 59
- D. BILGE BLOWER 60
- 2. ENGINE AND STERN DRIVE 61
- SELECTION 62
- 3. UNDERWATER GEAR 63
- 4. SEACOCKS & STRAIN ERS 64
- 5. BILGE LAYOUT 66
- B ILGE LAYOUT (CONT.) 67
- SECTION 5 • FUEL SYSTEM 69
- O REPLACE THE FILTER: 72
- B. GENERAL: 72
- UELING PRECAUTIONS 72
- SECTION 6 • ELECTRICAL SYSTEM 75
- LECTRONIC INTERFACE MODULE 79
- IG. 6.5.1) 79
- IG. 6.5.2) 79
- BULB#CEC1141 83
- BULB#T125 83
- A. INTERNATIONAL RECEPTACLE 88
- IG. 6.14.1) 88
- LECTROLYTIC CORROSION AND 88
- INC ANODES 88
- LECTRICAL SCHEMATICS 91
- IRING DIAGRAM (1 OF 8) 91
- IRING DIAGRAM (2 OF 8) 92
- IRING DIAGRAM (3 OF 8) 93
- IRING DIAGRAM (4 OF 8) 93
- IRING DIAGRAM (5 OF 8) 94
- IRING DIAGRAM (6 OF 8) 94
- IRING DIAGRAM (7 OF 8) 95
- IRING DIAGRAM (8 OF 8) 96
- . 6.23.1) DRAWING NO. 09-605 97
- ABIN DC WIRING DIAGRAM 98
- TEREO SYSTEM SCHEMATIC 99
- ATELLITE STEREO DIAGRAM 108
- ORTHSTAR 6000I SYSTEM DIAGRAM 108
- NTERCONNECT DIAGRAM 109
- OLVO SYSTEM DIAGRAM 110
- ILGE HARNESS 111
- ENERATOR HARNESS 113
- ABIN HARNESS 114
- REMIER STEREO HARNESS 115
- POILER HARNESS 116
- 2. CARBON MONOXIDE MONITOR 117
- (OPTIONAL) 117
- 4. WATER SYSTEM 118
- B. WATER PUMP AND FILTER 119
- D. SHOWER SYSTEM 120
- E. TRANSOM SHOWER 121
- F. DOCKSIDE WATER INLET 121
- ! WARNING 121
- 6. HEAD SYSTEM 122
- B. VACUFLUSH 123
- C. HOLDING TANK OPERATION 123
- D. VENT FILTER 123
- 7. MACERATOR DISCHARGE PUMP 124
- SEACOCK INTERLOCK SYSTEM 124
- A. GASOLINE ENGINE BOATS 125
- B. DIESEL ENGINE BOATS 125
- 9. EN TER TAIN MENT SYSTEM 126
- 10. REFRIGERATOR 127
- 11. CANVAS 127
- 12. HORN 128
- 13. SPOT LIGHT (OPTIONAL) 128
- 14. UNDERWATER LIGHTING 128
- INTERVAL 130
- SEFUL SERVICE INFORMATION 131
- 3. INSPECTION, SERVICE AND 132
- PROTOCOL 132
- BOATS STORED ON LAND 133
- D. HEAD SYSTEM 134
- E. WATER SYSTEM 134
- F. FUEL SYSTEMS 134
- 6. SECURITY CONSIDERATIONS 135
- 5. FITTING OUT AFTER STORAGE 135
- 7. SEACOCK LUBRICATION 136
- UICK REFERENCE CHECKLIST 137
- A. BOARDING THE BOAT* 137
- OAT SYSTEMS 137
- C. WHILE UNDERWAY 139
- D. RETURNING TO PORT 139
- E. SECURING THE BOAT 140
- AINTENANCE LOG 142
- 2. FIBERGLASS AND GELCOAT 143
- 1. PAINT CLEANING AGENTS AND 143
- OTHER SUBSTANCES 143
- B. SALT CRYSTALS 144
- ANVAS AND CLEAR VINYL 145
- CRYLIC PLASTIC SHEETING 145
- LASTIC GLASS) 145
- AUGE AND SWITCH PANELS 145
- XTERIOR UPHOLSTERY FABRIC 146
- NTERIOR UPHOLSTERY FABRIC 146
- Index iv 150
Related products and manuals for Power generators Sea Ray 290 Sundancer
(67 pages)© 2020, manymanuals.com. All rights reserved. | 1.782 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals