Sea Ray 390 Sundancer Owner's Manual Page 57

  • Download
  • Add to my manuals
  • Print
  • Page
    / 184
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 56
2.23
SECTION 2 • GENERAL BOAT ARRANGEMENT
390 Sundancer
®
(
425 Sundancer
®
)
NAVIGATION LIGHTS
(FIG. 2.23.1)
GREEN LIGHT
(VISIBLE 2
NAUTICAL MILES)
RED LIGHT
(VISIBLE 2
NAUTICAL MILES)
MAST LIGHT,
WHITE LIGHT
(VISIBLE 3
NAUTICAL MILES)
ALL-ROUND LIGHT,
WHITE LIGHT
(VISIBLE 3
NAUTICAL MILES)
STERN LIGHT,
WHITE LIGHT
(VISIBLE 2
NAUTICAL MILES)
The SRN power supply is powered through the 12
volt electronics fuse block under the helm. If the
SRN fails to turn on check the power switch on the
SRN power supply and the fuse on the fuse block.
REFER TO OWNER’S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
13. NAVIGATION AND ANCHOR LIGHTS
Navigation lights MUST be on while underway from
sunset to sunrise or in conditions of reduced
visibility. “Underway” means the boat is not docked
or at anchor. Trolling or drifting with engine off is
considered “underway” and navigation lights must
be used.
If you are anchored in open water, i.e. where other
boats can approach yours, you must display your
anchor light: a white light that can be seen from all
possible directions, i.e. 360 degrees.
Read the “Federal Requirements and Safety Tips
for Recreational Boats” provided in your kit.
TO OPERATE THE RUNNING LIGHTS:
Push RUNNING switch on control station switch
panel to the ON position.
TO OPERATE THE A NCHOR LIGHTS:
Push ANCHOR switch on control station switch
panel to the ON position.
if you opt to install additional equipment on the hard
top, it then becomes your responsibility to
reevaluate your lighting situation to make certain
the navigation lights on your boat meet government
navigational lighting requirements. You will most
likely have to raise the mast light. Consider the
weight of the equipment you install; be certain it is
not to heavy for your sport spoiler or optional hard
top.
14. CONSOLE DIMMER
There is a DIMMER control switch located on the
control station switch panel which controls the
intensity of the gauge and switch panel lights. The
gauge and switch panel lights are energized when
the navigation running lights are turned on.
Page view 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 183 184

Comments to this Manuals

No comments